Steps to Jump Start a Car

Owning a car is not just the fact that the tank is filled, the wiper fluid in the car and the tire pressure is not lower than the number specified in the manual. Who owns a machine must know how to change a tire, changing oil, and must know how to jump start the battery in their car when the car stalls, while on the road. Jump start a car is not as easy as it seems and there are a handful of steps that must be followed forJump start, to be carried out successfully and safely.

The first step to initiate a jump, a car park for the bridge in the immediate vicinity of the vehicle stalled. In general, most of the cars jumper only five feet or so from the car stalled with their sides facing each other are provided. So make sure not to touch the two cars in any way. Be sure to clean cables and you never leave them hanging in the engine compartment, where they can get caught on your belt or the fan. Once the jumper cableswere prepared for the project to ensure that the engine is turned off in both cars and the parking brake every car. Make sure car is in neutral or park Turn all the lights and radio, but are based on the hazards, if you are on the side of a road.

Jump Starter

Now you can begin the process of jumping. Place a jumper cable to the positive terminal of good battery installed on the vehicle. Then connect the other end of positive cable to the positive battery terminalCar jumper. Now connect the negative cable to the negative battery terminal end of the car on the bridge. Connect the other end of the negative cable for unpainted metal surface on the engine of the car stalled. In this way the vehicle is now founded on.

Before performing the early departure, check one last time to ensure that the cables are firmly attached to the vehicle and are not close to parts in motion. Now you can leave your car and bridgethat for a few minutes at idle. Once the load has been done for about five minutes you can start the car stalled. Once the vehicle stalled starts, make sure that both the vehicles and get them to stay for another five minutes or so to a minimum. If the stalled vehicle can not be started, do not try again. This will damage the starter motor of the vehicle stalled.

Once you are able to restart the stalled car can start disconnecting the starter cable. Get them out in reverse order, asThey put on. Also, do not let them touch or something under the hood. To ensure that the vehicle stalled stalled yet, take him to a body shop for a full battery charge, and soon again.

Steps to Jump Start a Car

fagor pressure cooker replacement parts Complete Tripod Units